Installation guide

Chapter 2 Installation
23
Below are single-bus (no duplex board) hot-swap drive configurations and SCSI
addresses (IDs) for the secondary cage in a rack-mounted HP NetServer. Load
drive modules with all necessary drive spacers starting at the bottom of the cage,
as described in "Installing Hot-Swap Drives" later in this chapter. Filler panels
must occupy all locations without disk drive modules.
10
10 12 13 14 15 10 12 14 15
10
12
13 15
11 12 13 14 15 10 12 14
10
11
12 14 15
Drive Spacer
Drive Spacer Drive Spacer
Drive Spacer
Drive Spacer Drive Spacer
Drive Spacer
Drive Spacer
Drive Spacer
Load Load
Load
Figure 2-13. SCSI IDs for Single-Bus Configurations in Rack Orientation