Installation guide

Chapter 2 Installation
22
Below are single-bus (no duplex board) hot-swap drive configurations and SCSI
addresses (IDs) for the secondary cage in a pedestal HP NetServer. Load drive
modules with all necessary drive spacers starting at the bottom of the cage, as
described in "Installing Hot-Swap Drives" later in this chapter. Filler panels must
occupy all locations without disk drive modules.
15
15
15
14
15
13
13
14
12
12
12
10
10
10
14
12
11
10
14
12
10
15
14
13
12
11
10
Drive Spacer
Drive Spacer
Drive Spacer
Drive Spacer Drive Spacer
Drive Spacer
Drive Spacer
Drive Spacer
Drive Spacer
Load
Load
Load
Figure 2-12. SCSI IDs for Single-Bus Configurations in Pedestal Orientation