Installation guide

Chapter 2 Installation
11
4. Using the two circular access holes in the chassis shown in Figure 2-3,
insert and tighten two screws supplied with the upgrade kit.
◊ HP NetServer LH 3000 and LH 6000 access holes are on the side of the
chassis.
◊ HP NetServer LH 3000r and LH 6000r access holes are on the top of
the chassis.
Figure 2-3. Insert and Tighten Two Screws (1),
and Then Insert and Tighten Six Screws (2)
5. Insert six screws into the front of the hot-swap mass storage cage, as
shown in Figure 2-3, and tighten them.