Installation guide

2 Installation

Installation Overview

NOTE If you plan to install a duplex board on the second hot-swap

mass storage cage, do so before you install the cage. Refer to

HP NetServer Duplex Kit Installation Guide for instructions.

Installing a second hot-swap mass storage cage in your HP NetServer requires

these general steps, which are described in this chapter:

•

Step 1: Power Down and Disconnect

• Step 2: Unlock and Remove Front Bezel

• Step 3: Remove Cover 1 and Cover Plate

• Step 4: Install Mass Storage Cage

• Step 5: Remove Fan Assemblies

• Step 6: Install SCSI Cable

• Step 7: Connect Power Harness

• Step 8: Replace Fan Assemblies

• Step 9: Replace Cover 1 and Front Bezel

• Step 10: Install Hard Disk Drive Modules

• Step 11: Reconnect Power Cords and Other Cables

• Step 12: Verify Installation

After you finish the installation, go to Chapter 3 to configure your mass storage.

Step 1: Power Down and Disconnect

Do the following to power down and disconnect the HP NetServer:

1. Back up your system.

2. Bring down the network properly.