User guide

Chapter 8 Mounting the NetServer in a Rack

Type 1--Mounting the Slides

Once you have marked the locations of the slides, attach them. To do so for the

"Type 1" Rack, follow these steps :

◊ First, orient the slides so the slide members extend out the front

of the rack.

◊ Insert screws through the rack column and start them in one bar nut at

the correct location on each column (see Figure 8-5). Prepare to insert

the mounting flange of the slides between the column and the bar nut.

(Refer to Figure 8-6.)

◊ Then line up the front and rear mounting flanges of the slide with the

screws started in the bar nuts. Press the slide firmly against the rack

column. See Figure 8-8.

◊ Tighten all four screws in the mounting flanges of each slide.

Mounting

Flange

Then insert the

mounting flange

in place on

each column and

tighten the screws.

For Type 1 rack, insert

screws through all four rack

columns and start them in bar nuts.

Figure 8-8. Orientation and Fastening of Type 1 Slides