QuickSpecs

QuickSpecs
HP MultiSeat Computing Solution
HP Compaq MultiSeat ms6000 Desktop Technical Specifications
DA – XXTBD Worldwide —Version 1 — November 2009
Page 5
Audio
Integrated High Definition audio with internal speaker
Front – mic and headphone
Rear – input (supports microphone or line input), line out
NIC (RJ-45)
Integrated Intel 82567LM Gigabit Network Connection Ethernet
Intel Q43 Express chipset
*
One of these:
Intel Core 2 Duo
E7500 Processor (2.93
-
GHz, 3 MB L2 cache, 1066
-
MHz FSB)
Intel Core 2 Quad Q9500 Processor (2.83-GHz, 6 MB L2 cache, 1333-MHz FSB)
* Intel processor numbers are not a measure of performance. Processor numbers differentiate features within each
processor
family, not across different processor families.
The Intel Q43 Express chipset supports un-buffered non-ECC DDR3 SDRAM (synchronous
dynamic random access memory) of up to 2GB total memory (essential configuration) at a
frequency of up to 1066MHz or 4GB (extended configuration) at a frequency of up to
1333MHz.
NOTE: 1066MHz system memory frequency of operation requires at least PC3-8500 (DDR3-
1066) memory type for all populated memory modules, and an Intel processor with FSB (front
side bus) of at least 1066MHz.
System Memory upgrades are accomplished by adding DDR3 SDRAM module(s) to empty DIMM
slots on the System Board.
CAUTION: Voltage is supplied to the memory modules whenever the computer is connected to
an active AC outlet. Adding or removing memory modules while voltage is present may cause
irreparable damage to the memory modules or system board. The computer must be shut down
with the AC power removed (disconnect AC power cord at rear chassis or at AC outlet) prior to
adding or removing SDRAM modules.
HP recommends dual-channel symmetric configurations for the best memory performance.
For best performance, add the same amount of total memory to each channel and do not inter-
mix memory module speeds. For dual-channel symmetric performance, the total amount of
memory in each channel must be equal. If memory module speeds are inter-mixed, the memory
operating frequency will default to the slowest speed.
*
Supports up to 16GB of un-buffered non-ECC DDR3 SDRAM. Slot 1 is black and must
always be populated. Not all possible memory configurations are
represented in the table below.
NOTE: For systems configured with more than 3GB of memory and a 32-bit operating system, all
memory may not be available to the OS due to system resource requirements. Addressing memory
above 4GB requires a 64
-bit operating system.
Supports un-buffered non-ECC DDR3 SDRAM
Maximum Memory
Chipset
Processor and
Speed
Memory