Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

304 AppendixA
NMS Error Messages
FMT Error Messages
4028 MESSAGE: Range error at position shown; other values accepted if
allowed
CAUSE: One of the numbers you entered was out of range; a “^^”
indicator appears below the illegal number. The number entered was
probably much too large.
ACTION: The bad value was not accepted. Press the
Return key to keep
the other values on the same line, or else retype the entire input using
only legal values.
4029 MESSAGE: Syntax error at position shown; other values accepted if
allowed
CAUSE: Some of the numbers on the input line contained illegal
characters, or were separated by illegal characters. Legal inputs are
digits 0–9 and the question mark “?”. Legal separators for a list are the
comma “,” and the blank “ ”.
ACTION: Retype the input.
4030 MESSAGE: Invalid set number NN; reenter all or hit RETURN to keep
others
CAUSE: One of the filter-set numbers you selected is not one of the valid
filter sets for this formatter.
ACTION: Check your input against the available sets shown in the
menu. Press the
Return key to keep the other number(s) you entered on
the same line, or you may retype the entire input. You may also return
to the main menu and “set all options back to their default values.”
4031 MESSAGE: Output limit out of range; enter another number or hit
RETURN
CAUSE: You have selected a value which is less than the lower output
limit or greater than the upper output limit.
ACTION: The value you selected was not accepted. Reenter a value
which is within the range shown in the prompt. The prompt is meant as
a reminder; values up to 4096 are also legal.
4032 MESSAGE: Invalid option number NN ignored; others accepted
CAUSE: One of the option numbers you selected at the main menu was
not a valid option number for this formatter.
ACTION: The illegal option number was ignored, but any other options
on the same line were executed. Check your input and retype if
necessary.