Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

276 AppendixA
NMS Error Messages
NMMGRVER Messages, Errors and Warnings
Install the newer version of NMC and run the newer NMMGRVER if
needed or, restore an old configuration file if possible and rerun
NMMGRVER.
NMMGRVER
WARN 12
MESSAGE: File NMCONFIG.PUB.SYS couldn’t be opened.
(NMMGRVERWARN 12)
CAUSE: NMCONFIG was already open for exclusive access, or
MIDASOPEN detected an error.
ACTION: Check NMCONFIG and retry.
NMMGRVERERR
13
MESSAGE:
Error during merge of configuration files.
Path: !
Midasstat = !
(NMMGRVERERR 13)
CAUSE: There is an error in one of the cells in the file hierarchy. This
error has been detected as an error in the configuration file.
ACTION: Check the midasstat value to determine what the problem is.
It may be necessary to use some other tool to determine which cell has
the problem. If possible, manually edit the data in this cell and verify it
manually. If this is not possible, delete the cell and run NMMGRVER
again.
CAUSE: The configuration file is corrupted.
ACTION: Since the destination file has been changed, recovery is not
possible. Restore a backup copy of the configuration file if possible and
run NMMGRVER again. If the error still occurs, submit a Change
Request. See “Submitting a CR” at the beginning of this appendix.
NMMGRVERERR
14
MESSAGE:
Path not found in the config file.
Path: !
(NMMGRVERERR 14)
CAUSE: This may be a normal condition if the user does not have NS on
the system. However, it may also indicate that you are trying to convert
NMCONFIG.PUB.SYS on a non-XL system, when you should actually be
converting an NSCONF-like file.
ACTION: The conversion will operate correctly. The user is being
warned to be sure that the correct file is being converted.
NMMGRVERERR
15
MESSAGE:
Invalid data length.
Path: !
Length: !
(NMMGRVERERR 15)
CAUSE: The length of the data array which was read from the cell was