Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

Appendix A 271
NMS Error Messages
NMGR Error and Warning Messages
to correct the card configuration, then reenter the SUMMARYCONF
command.
NMGRERR 557 MESSAGE: That Port is not configured in the DTC and Card specified.
(NMGRERR 557)
CAUSE: You specified an incorrect port number while using the
SUMMARYCONF command to obtain a DTS critical summary report on a
specific card in a specific DTC. Either the DTC does not exist, the card
specified is not configured for that DTC, or the port is not configured for
that card.
ACTION: Reenter the command with the correct port number, card
number, and DTC specified. If the port exists but is not properly
configured, use NMMGR to correct the configuration, then reenter the
SUMMARYCONF command.
NMGRERR 558 MESSAGE: The DTC subsystem has not been configured.
(NMGRERR 558)
CAUSE: You entered a SUMMARYCONF DTS command on a system
where no distributed terminal subsystem is configured (the HOST/PC
flag has not been set).
ACTION: Configure the distributed terminal subsystem, then reenter
the SUMMARYCONF DTS command.
NMGRERR 559 MESSAGE: Illegal delimiter given. Type HELP for command syntax.
(NMGRERR 559)
CAUSE: While using the SUMMARYCONF command to obtain a DTS critical
summary report, you entered an illegal delimiter.
ACTION: Type HELP at the prompt to access the HELP messages for the
SUMMARYCONF command. Study these messages to determine the proper
syntax to obtain the desired information. Reenter the command using
the correct delimiters.
NMGRERR 560 MESSAGE: The card number must be an integer from 0 to 5.
(NMGRERR 560)
CAUSE: While using the SUMMARYCONF command to obtain a DTS critical
summary report on a specific card in a DTC, you entered an invalid card
number. Card numbers must be entered as integers, from 0 to 5.
ACTION: Reenter the command with a card number specified in the
valid range, 0 through 5.