Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

270 AppendixA
NMS Error Messages
NMGR Error and Warning Messages
NMGRERR 552 MESSAGE: Extra data was specified in the command line.
(NMGRERR 552)
CAUSE: While using the SUMMARYCONF command to obtain a DTS critical
summary report on a range of logical devices, you entered more data
than was expected in the command line.
ACTION: Reenter the command with the parameters specified in the
correct format (LDEV [xxx[/yyy]], where xxx and yyy are integers).
NMGRERR 553 MESSAGE: The lower LDev # must be less than the upper LDev #.
(NMGRERR 553)
CAUSE: While using the SUMMARYCONF command to obtain a DTS critical
summary report on a range of logical devices, the first LDEV number
you specified was higher than the second LDEV number you specified.
This is an invalid range specification.
ACTION: Reenter the command with the LDEV range specified
correctly, with the first number in the range lower than the second
number in the range.
NMGRERR 554 MESSAGE: There are no LDevs within the specified range.
(NMGRERR 554)
CAUSE: While using the SUMMARYCONF command to obtain a DTS critical
summary report on a range of logical devices, you specified a valid
range; however, there are no LDEVs within that range.
ACTION: Reenter the command with a correct range of logical devices
specified (one that includes LDEVS).
NMGRERR 555 MESSAGE: The DTC Name specified is not configured.
(NMGRERR 555)
CAUSE: You specified an incorrect DTC name while using the
SUMMARYCONF command to obtain a DTS critical summary report on a
specific DTC. Either the DTC does not exist or no data has been
configured for that DTC.
ACTION: If the name was entered incorrectly, reenter the SUMMARYCONF
command with the correct DTC name specified. If the DTC exists but is
not correctly configured, use NMMGR to configure the data for the
DTC, then reenter the SUMMARYCONF command.
NMGRERR 556 MESSAGE: The Card specified is not configured in the specified DTC.
(NMGRERR 556)
CAUSE: You specified an incorrect card number while using the
SUMMARYCONF command to obtain a DTS critical summary report on a
specific DTC. Either the DTC does not exist or the card specified is not
configured for that DTC.
ACTION: Reenter the command with the correct card number and DTC
specified. If the card exists but is not properly configured, use NMMGR