Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

Appendix A 247
NMS Error Messages
NMGR Error and Warning Messages
NMGRERR 257 MESSAGE: The NI name does not exist. Please specify a type to
create it. (NMGRERR 257)
CAUSE: At the Guided HP Configuration screen, the user entered a new
NI name and pressed the
Config Network key without specifying a type
in the NI type field. The type must be specified if the NI does not
already exist.
ACTION: If you are configuring a new NI, enter the type of the new NI
in the NI type field and press
Config Network. If you are updating an
existing NI and entered the wrong name in the NI name field, enter the
correct NI name and press
Config Network.
NMGRERR 258 MESSAGE: Data saved, but profile doesn’t exist. Use GoToProfiles
command to create it. (NMGRERR 258)
CAUSE: At the DTS Configuration screen or at one of the DTC card
configuration screens, the user specified the name of a profile that is not
configured and then pressed the
save data key.
ACTION: Press the
Go To Profiles key if one exists for the screen. If not,
type GoToProfiles in the command line and press
Enter. This will take
you to the profile configuration screens. Configure the nonexisting
profile(s) and save the information in the configuration file. When you
are finished, press the
Prior Screen key until NMMGR returns you to
the screen you were at when you originally entered the nonexisting
profile name. There is no need to reenter the data on this screen, since
it has already been saved. Continue with the next configuration task.
NMGRERR 259 MESSAGE: A DTC name must be specified. (NMGRERR 259)
CAUSE: At the DTC Configuration screen, the user pressed the
Read
DTC function key without specifying a DTC name.
ACTION: Enter a valid DTC name and try again.
NMGRERR 260 MESSAGE: The DTC name does not exist; enter data and press Save
Data to create it. (NMGRERR 260)
CAUSE: At the DTC Configuration screen, the user specified a
nonexisting DTC name and pressed either the
Config Card key or the
Read DTC key.
ACTION: If an incorrect DTC name was entered, enter the correct DTC
name and try again. If the DTC name is correct but the DTC has not yet
been configured, enter the information for the DTC and press the
Save
Data key, then try again.
NMGRERR 261 MESSAGE: The DTS Link does not exist. Enter a Link name and press
Sate Data. (NMGRERR 261)
CAUSE: At the DTS Configuration screen, the user entered a
nonexisting link name and pressed the Tune DTS Link key.