Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

Appendix A 235
NMS Error Messages
NMGR Error and Warning Messages
ACTION: See “Submitting a CR” at the beginning of this appendix.
NMGRERR 101 MESSAGE: Internal error: Midas file number not in file table.
(NMGRERR 101)
CAUSE: The file number was not located in a search through the table.
It is likely that a file number was changed in NMMGR but not entered
in the table.
ACTION: Exit NMMGR, and rerun NMMGR and try to observe what
damage has been done. Repair if possible or restore the configuration
file. If the problem still exists, see “Submitting a CR” at the beginning
of this appendix.
NMGRERR 102 MESSAGE: Internal error: Unable to remove closed file from file table.
(NMGRERR 102)
CAUSE: An attempt to clear the file table of a closed file failed.
ACTION: Exit NMMGR. It is possible that no damage occurred. Rerun
NMMGR. If the problem still exists, see “Submitting a CR” at the
beginning of this appendix.
NMGRERR 103 MESSAGE: Internal error: NMMGR file table inconsistent.
(NMGRERR 103)
CAUSE: On trying to access the file table, an error was found in the
table. This will happen at open time if an attempt is made to put a file
into the file table and if the slot in the table is already occupied.
ACTION: Exit NMMGR. It is possible that no damage occurred. Rerun
NMMGR. If the problem still exists, see “Submitting a CR” at the
beginning of this appendix.
NMGRERR 104 MESSAGE: Netxport has locked the file; cannot begin guided task;
wait. (NMGRERR 104)
CAUSE: The network transport is being started using the file that
NMMGR has open as the active configuration file. A guided dynamic
update cannot be started until the transport has been started.
ACTION: Wait until the transport is started and then try again.
NMGRERR 105 MESSAGE: The file has been locked; type ‘STOP’ to abort, or wait.
(NMGRERR 105)
CAUSE: Either the transport is being started using the file NMMGR has
open as the active configuration file, or NMMGR is processing a guided
dynamic update which cannot continue until the transport has been
started.
ACTION: Wait until the transport is started and then try again.