Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

208 AppendixA
NMS Error Messages
NM Error Messages
NMERR 177 MESSAGE: Locked(!) HW Recover(!) HW Sick(!) HW Dead(!)
Resource(!). Run diagnostics for more information. (NMERR 177)
CAUSE: This message is likely caused by a hardware problem, and is a
generic status request to the I/O manager returned with the specified
bits set. One particular example is that the user has entered the
LINKCONTROL command while the system is in power fail recovery.
ACTION: Correct the problem and try again.
NMERR 178 MESSAGE: Link H/W device indicates self test failure. Run
diagnostics for more information. (NMERR 178)
CAUSE: A failure has occurred in the datacomm hardware.
ACTION: Run diagnostics and replace the defective hardware as
necessary.
NMERR 179 MESSAGE: Unexpected internal error accessing I/O manager.
(NMMERR 179)
CAUSE: The I/O Manager is an unknown state.
ACTION: Run diagnostics for more information.
NMERR 181 MESSAGE: Trace buffer size must be in the range 1 to 16.
(NMERR 181)
CAUSE: The user has entered a number that is not in the acceptable
range. The current buffer sizes supported are within the ranges of 1K to
16K. Returned by the LINKCONTROL command parsing routine.
ACTION: Enter a valid number (1 through 16).
NMERR 182 MESSAGE: HPE status : info =!, subsystem ID = !. (NMERR 182)
CAUSE: Status information reported by each individual module.
ACTION: Look at “DHPESTAT.HPESTD.OFFICIAL” for the definitions
of subsystem constants. Find out the error information by checking the
status reporting file for that particular module.
NMERR 185 MESSAGE: Only the LANIC link is supported. (NMERR 185)
CAUSE: No link other than LAN is currently supported.
ACTION: Specify only the LANIC for this application.
NMERR 186 MESSAGE: Trace request for
linkname failed due to : HPE status:
INFO = ! subsystem ID = !.
CAUSE: You attempted to start or stop tracing, but tracing was already
enabled or disabled.
ACTION: None.
CAUSE: An improper value was specified in the LINKCONTROL command.
ACTION: Reissue the LINKCONTROL command with the correct value.