Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

Appendix A 177
NMS Error Messages
NMCN Error and Warning Messages
NMCNERR 45 MESSAGE: NM Log Process: Cannot format log msg. Cannot access
formatter for subsystem !. Encountered LOADPROC error !.
(NMCNERR 45)
CAUSE: A request to write a formatted log message specifies an NMS
subsystem number where formatter Log Process was unable to
LOADPROC.
ACTION: The SUBSYS
n LOGFORMA procedure, where n is the subsystem
number specified in the message, either did not exist in SL.PUB.SYS or
could not be loaded when NM Log Process started. Look up the
LOADPROC error number in the MPE Intrinsics Reference Manual.
Correct this error. Check that NMS subsystem
n is completely, correctly
installed. See “Invalid Software Installation” and “Insufficient MPE
Resources” at the beginning of this appendix.
NMCNERR 46 MESSAGE: NM Log Process: Cannot format log msg. Unknown
subsystem
nn . (NMCNERR 46)
CAUSE: A request to write a formatted log message specifies an
unknown NMS subsystem number.
ACTION: This is an internal error. See “Submitting a CR” at the
beginning of this appendix.
Table A-1 Subsystem Numbers for NMCNERR Messages
nn Subsystem
0 Node Management Services (30299-11017)
1 SNA Transport (32099-11015)
2 SNA/NRJE (Product #30245)
3 Network Transport (Product #30242)
4 Port Translator (30299-11017)
5 Sockets
6 Network Services (Product #32344)
7 Buffer Manager (30299-11016)
8 Link Manager (part of Node Management Services)
9 Reserved for future use
10 Reserved for future use
11 SNA/IMF
12/15 Reserved for future use