Manualshelf

Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

ManualsBrandsHP ManualsSoftwareMPE/iX 7.5 Operating System
919293949596979899100
TermDSM Messages
Appendix A
98
CAUSE: The DTC was trying to power up at the same time you were trying to access it.
ACTION: Wait for the download, or upload/download, to complete (as shown by the
console messages). Verify then that the DTC is operational. If not, contact your HP
support representative.
(TDSM 249) MESSAGE: The DTC requested that it be dumped during the operation. (TDSM 249)
CAUSE: The DTC detected an internal error at the same time you were trying to access it
through TermDSM.
ACTION: Wait for the download, or upload/download, to complete (as shown by the
console messages). Then verify if the DTC is operational. If not, contact your HP support
representative.
(TDSM 250) MESSAGE: DTC and host RMP versions are incompatible. (TDSM 250)
CAUSE: Incompatibilities were found between subsystem software on the HP 3000 and
subsystem software on the DTC.
ACTION: Contact your HP support representative.
(TDSM 251) MESSAGE: Bad RMP packet received from DTC. (TDSM 251)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 252) MESSAGE: Could not open the download or dump file. (TDSM 252)
CAUSE: Files pertaining to this operation cannot be accessed.
ACTION: If this is a dump, verify that sufficient disk space exists to create the dump file.
Approximately 2200 sectors of disk space is required. If enough disk space is available
(or if you were not trying to perform a dump operation), contact your HP support
representative.
(TDSM 253) MESSAGE: Unable to get a system timer. (TDSM 253)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 255) MESSAGE: Dump overflow: DTC sent more data than expected. (TDSM 255)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 255) MESSAGE: Dump overflow: DTC sent more data than expected. (TDSM 255)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 260) MESSAGE: Bad NMP error code received. (TDSM 260)
CAUSE: Unknown error reported by the Distributed Terminal Subsystem to TermDSM.
ACTION: Contact your HP support representative.
(TDSM 261) MESSAGE: Bad RMP return code received. (TDSM 261)
CAUSE: Unknown error reported by the Distributed Terminal Subsystem to TermDSM.
ACTION: Contact your HP support representative.