Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)
Appendix A
87
A TermDSM Messages
(TDSM 15) MESSAGE: You have entered an unknown or incorrect command. Please try again.
(TDSM 15)
CAUSE: You have entered something that is not a TermDSM command or a command
that is not valid in this context.
ACTION: Commands that are valid at this time are listed in the prompt. Please try again.
Type HELP or refer to Chapter 4, “TermDSM Commands,” for more information.
(TDSM 16) MESSAGE: TermDSM has compiled without $partial eval$ in effect. It cannot continue.
This problem must be fixed at the factory. (TDSM 16)
CAUSE: Internal error.
ACTION: Contact your Hewlett-Packard support representative.
(TDSM 17) MESSAGE: Your security level (3) is too low to use TermDSM. Please log on with level
0, 1, or 2 security. (TDSM 17)
For level 0, you need SM capability.
For level 1, you need SM or DI capability.
For level 2, you need SM or DI or OP capability.
CAUSE: You do not have the correct user capabilities to use TermDSM.
ACTION: Logon as a user with the correct capabilities for the TermDSM functions you
wish to use. Refer to Chapter 4, “TermDSM Commands,” for the security levels of each
command and subcommand.
(TDSM 18) MESSAGE: You have entered a bad port number. Port numbers range from 0 to 23.
(TDSM 18)
CAUSE: You have entered an invalid port number. Port numbers range from 0 to 7 for
DTC 16 and DTC 48, from 0 to 15 for DTC 16iX/16MX, and from 0 to 23 for DTC 72MX.
ACTION: The port number was not entered or is unrecognizable.
(TDSM 19) MESSAGE: The port number is missing or invalid. Port numbers range from 0 to 23.
(TDSM 19)
CAUSE: Internal error.
ACTION: Enter a valid port number. Refer to the prompt or Chapter 4, “TermDSM
Commands,” for syntax.
(TDSM 20) MESSAGE: You have entered a bad ldev number. Ldev numbers are positive integers.
(TDSM 20)
CAUSE: The value that you entered as a logical device number is not a number greater
than zero.
ACTION: Enter a valid ldev number. Note that you can also use the POrt subcommand.
(TDSM 21) MESSAGE: The ldev number is missing or invalid. Ldev numbers are positive integers.
(TDSM 21)
CAUSE: The logical device number was not entered or is unrecognizable.
ACTION: Enter a valid ldev number. Note that you can also use the POrt subcommand.