Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Commands
S[TATUS]
Chapter 4
74
The following is a brief explanation of key fields displayed on the terminal:
• Revision Number. Provides version number of SIC hardware and software.
• Current Host Name. If a connection is active, and it was initiated by the terminal,
then this is the name of the host to which the port is connected. Otherwise, this field
is blank.
• Port Type. The type of DTC connector card attached to the port.
• Connection State. The status of the connection between the port and the MPE/iX
system. Possible values are:
— Disconnected. Port is not in use; no MPE/iX session is active on this port.
— Connect from AFCP Pending. MPE/iX has requested and is awaiting a
connection to this port.
— Connect from DIODAM Pending. Device has requested and is awaiting a
connection to the MPE/iX.
— Connected. The port is connected to an MPE/iX system.
— Disconnect from AFCP Pending. MPE/iX has requested and is awaiting
disconnection from the port.
— Disconnect from DIODAM Pending. Device has requested and is awaiting
disconnection from MPE/iX.
— Bad. The port has failed its selftest, or this is a non-existent port on the SIC.
The remaining fields contain detailed diagnostics information for use by HP support
representatives. Further explanation of these fields is beyond the scope of this manual.
S[TATUS] SN[P]
Obtains status information about a particular X.25 card.
Security level: 2.
Syntax
SN[P] dtcnum,cardnum,optionnum
Parameters
dtcnum
Number of the DTC that contains the X.25 (SNP) card. This is the
number TermDSM associates with this DTC.
cardnum
Number of the X.25 card within the DTC. The cards are numbered
from zero beginning at the bottom of the DTC. (Note that SNP cards
may not be mounted in slot 0 or 1 for DTC 16, and slot 0 for DTC 48.)
optionnum
Number of the option. One of the following four options must be
specified:
1 for global
2 for level 2
3 for level 3
4 for PAD status.