Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Commands
R[ESET]
Chapter 4
67
R[ESET]
To clear hardware and software associated with a logical device number, physical port,
serial interface card, or DTC so that a new session or job can be started on each port.
Security level: 1 for DTC; 2 for remaining functions.
Syntax
R[ESET]
Description
After the RESET command is entered, the following prompt is printed on the terminal:
(reset)
Ldev #
POrt #,#,#
SNp # ,#(X.25 card in DTC)
Vc #,#,#
SIc # ,#multiplexer card in DTC)
DTc #
(carriage return to exit) ?
These are the subcommands that can then be entered. The following pages describe each
of these options.
If you press
[Return]
instead of one of the subcommands, you will be returned to the
major prompt and may then enter another TermDSM command.
Some port/ldev problems can not be fixed with ldev or port resets. If a port is still
unusable after a reset, consider using RESET SIC. Note that this will affect all users on
that card. Finally, if the RESET SIC is also unsuccessful, then the entire DTC should be
reset. Note that this will affect all the users on the DTC.
R[ESET] DT[C]
Resets the hardware of a particular DTC or group of DTCs.
Security level: 1.
Syntax
DT[C] dtcnums
Parameter
dtcnums
The DTC number TermDSM associates with a particular DTC. The DTC
command lists each DTC with its assigned DTC number.