Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Commands
DU[MP]
Chapter 4
61
Please deliver the following SNP dump to your HP representative.
C
bxxxxxa .PUB.SYS
where
b
is the board number in that DTC,
xxxxx
is the last 5 characters of the IEEE
802.3 address of that DTC and a is a character in the sequence a, b, ...,z to allow multiple
dumps.
DU[MP] V[C]
Captures data pertaining to a particular VC on an X.25 card and writes it to a disk file.
(If the VC you are attempting to dump is a PAD VC, you must use the Ldev option
instead.)
Security level: 2.
Syntax
V[C] dtcnum,cardnum,vcnum
Parameters
dtcnum
Number of the DTC that contains the SNP (X.25) card. This is the
number TermDSM associates with this DTC.
cardnum
Number of the X.25 card within the DTC. The cards are numbered
from zero beginning at the bottom of the DTC. (Note that SNP cards
may not be mounted in slot 0 or 1 for DTC 16, and slot 0 for DTC 48.)
vcnum
Number of the VC on the X.25 card. (PAD VCs must be dumped using
the Ldev option.)
Description
Information associated with the VC on the X.25 card is dumped to a disk file.
NOTE Dumping information pertaining to a VC does not reset (or otherwise affect) the
associated device. If you need to reset the VC, use the RESET command.
When the dump is complete, the following information will be displayed:
Please deliver the following VC dump to your HP representative.
V
xxxxxxa .PUB.SYS
where
b
is the board number in that DTC,
xxxxx
is the last 5 characters of the IEEE
802.3 address of that DTC and a is a character in the sequence a, b, ...,z to allow multiple
dumps.