Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Messages
Appendix A
111
ACTION: Run NMMGR and correct the X.25 address configured for loopback on the level
3 configuration screen.
(TDSM 802) MESSAGE: The call has been refused by the network. Verify the address configuration
and the number of VCs configured. (TDS M802)
CAUSE: The user was attempting to perform a loopback test on an SNP card but the
network would not accept the call.
ACTION: Run NMMGR to correct any problems with the DTC/X.25 Network Access card
(SNP card) configuration.
(TDSM 803) MESSAGE: Bad card. (TDSM 803)
CAUSE: The DTC/X.25 Network Access card (SNP) being tested is bad.
ACTION: Contact your HP support representative.
(TDSM 804) MESSAGE: All ports are bad. (TDSM 804)
CAUSE: All ports on the DTC/X.25 Network Access card (SNP) being tested are bad.
ACTION: Contact your HP support representative.
(TDSM 805) MESSAGE: Some ports are bad. (TDSM 805)
CAUSE: Some ports on the DTC/X.25 Network Access card (SNP) being tested are bad.
ACTION: Contact your HP support representative.
MESSAGE: Unknown Cable. (TDSM 806)
(TDSM 806) CAUSE: TermDSM does not recognize the cable interfacing the DTC/X.25 Network Access
card (SNP card) to the network.
ACTION: Replace cable with a supported network interface cable.