Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Messages
Appendix A
102
ACTION: Verify the number that TermDSM associated with the DTC containing the
DTC/X.25 XL Network Access card. Reenter the command with the correct DTC number
specified.
(TDSM 325) MESSAGE: Some other DTC is already tracing. (TDSM 325)
CAUSE: Only one DTC can be tracing at a time.
ACTION: Turn off tracing on the other DTC and try again.
(TDSM 326) MESSAGE: This requested DTC is already tracing. (TDSM 326)
CAUSE: Tracing has already been turned on for the specified DTC.
ACTION: None required.
(TDSM 327) MESSAGE: This DTC is not tracing. (TDSM 327)
CAUSE: Tracing is turned off on the specified DTC.
ACTION: Turn on tracing for the specified DTC.
(TDSM 328) MESSAGE: Invalid board number — out of range. (TDSM 328)
CAUSE: The specified board number does not exist.
ACTION: Check the board installed in the DTC and re-specify the correct board number.
(TDSM 329) MESSAGE: Indicated board is absent or is not an SNP card. (TD SM329)
CAUSE: The board specified does not exist in the DTC or is not an SNP card.
ACTION: Verify that the required board is in the DTC. If you are trying to configure an
SNP board, verify that the board you specified is an SNP board.
(TDSM 330) MESSAGE: Trace file could not be opened. (TDSM 330)
CAUSE: The file where tracing messages are logged could not be opened.
ACTION: Contact your HP support representative.
(TDSM 331) MESSAGE: X.25 has not been started on indicated SNP card. (TDSM 332)
CAUSE: The specified SNP card has not had X.25 started up on it.
ACTION: Contact your HP support representative.
(TDSM 332) MESSAGE: X.25 is not configured for indicated SNP card. (TDSM 331)
CAUSE: The indicated SNP card does not have X.25 configured for it.
ACTION: Contact your HP support representative.
(TDSM 333) MESSAGE: X.25 or X.25/PADSUP not stopped. (TDSM 333)
CAUSE: The operation you attempted required that X.25 or X.25/PADSUP be stopped
and it was still running.
ACTION: Start up X.25 on the specified card and try again or specify a card that has X.25
started.
(TDSM 334) MESSAGE: DTCM reports unexpected SIC UPLOAD request. (TDS M334)
CAUSE: Internal error.
ACTION: Contact your HP representative.
(TDSM 335) MESSAGE: This port is already under extended trace. (TDSM 335)