Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Messages
Appendix A
101
CAUSE: It has finished the download of its operating firmware before the DTCM expected
it.
ACTION: Look on the console for a “boot complete” message. Otherwise, enter the
command again. If the problem persists, contact your HP support representative.
(TDSM 308) MESSAGE: Unable to get an LLIO message frame. (TDSM 308)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 309) MESSAGE: DTCM produced an unknown action code. (TDSM 309)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 317) MESSAGE: Unable to get an outbound packet buffer. (TDSM 317)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 318) MESSAGE: Unable to write to an outbound packet buffer. (TDSM 318)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 319) MESSAGE: Unable to send an LLIO message. (TDSM 319)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 320) MESSAGE: DTCM encountered an unspecified error. (TDSM 320)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 321) MESSAGE: DTCM captured an unknown escapecode. (TDSM 321)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 322) MESSAGE: DTC configuration file too large for buffer. (TDSM 322)
CAUSE: Internal error.
ACTION: Contact your HP support representative.
(TDSM 323) MESSAGE: Please reset or dump the specific PAD VC from ldev option. (TDSM 323)
CAUSE: The user attempted to reset or dump a PAD VC using the VC subcommand. PAD
connections can only be dumped or reset from the Ldev subcommand.
ACTION: Determine the ldev number that is associated with the PAD connection and
retry the reset or dump operation using the Ldev subcommand.
(TDSM 324) MESSAGE: The system is a HOST BASED X25. However the specified DTC has no SNP
card. (TDSM 324)
CAUSE: There is no DTC/X.25 XL Network Access (SNP) card mounted in the DTC that
you specified in the TermDSM command.