Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

Appendix A 117
TermDSM Messages
ACTION: Verify the number that TermDSM associated with the DTC
containing the DTC/X.25 XL Network Access card. Reenter the
command with the correct DTC number specified.
MESSAGE: Some other DTC is already tracing. (TDSM 325)
(TDSM 325) CAUSE: Only one DTC can be tracing at a time.
ACTION: Turn off tracing on the other DTC and try again.
MESSAGE: This requested DTC is already tracing. (TDSM 326)
(TDSM 326) CAUSE: Tracing has already been turned on for the specified DTC.
ACTION: None required.
MESSAGE: This DTC is not tracing. (TDSM 327)
(TDSM 327) CAUSE: Tracing is turned off on the specified DTC.
ACTION: Turn on tracing for the specified DTC.
MESSAGE: Invalid board number — out of range. (TDSM 328)
(TDSM 328) CAUSE: The specified board number does not exist.
ACTION: Check the board installed in the DTC and re-specify the
correct board number.
MESSAGE: Indicated board is absent or is not an SNP card.
(TDSM 329)
(TDSM 329) CAUSE: The board specified does not exist in the DTC or is not an SNP
card.
ACTION: Verify that the required board is in the DTC. If you are trying
to configure an SNP board, verify that the board you specified is an
SNP board.
MESSAGE: Trace file could not be opened. (TDSM 330)
(TDSM 330) CAUSE: The file where tracing messages are logged could not be
opened.
ACTION: Contact your HP support representative.
MESSAGE: X.25 has not been started on indicated SNP card.
(TDSM 332)
(TDSM 331) CAUSE: The specified SNP card has not had X.25 started up on it.
ACTION: Contact your HP support representative.
MESSAGE: X.25 is not configured for indicated SNP card. (TDSM 331)
(TDSM 332) CAUSE: The indicated SNP card does not have X.25 configured for it.
ACTION: Contact your HP support representative.