System Startup, Configuration, and Shutdown Reference Manual (32650-90907)

Chapter 2

Initiating System Activity

System Startup Procedure

The following procedure is an example of what to enter and what it looks like to start a system. To initiate the

startup process enter:

CTRL B

NOTE If you have a 99X system, you must transfer to the service processor before you reset the

system.

CM> SP

If you have an N-Class system, a PDC screen is displayed. Type BO to boot from the primary

path.

Example 2-9 System Startup Procedure

GSP> tc

Execution of this command irrecoverably halts all system processing and

I/O activity and restarts the computer system.

Type Y to confirm your intention to restart the system: (Y/[N]) y

-> SPU hardware was successfully reset.

GSP Host Name: csyprel18(csysas18)

GSP>

********** VIRTUAL FRONT PANEL **********

System Boot detected

*****************************************

LEDs: RUN ATTENTION FAULT REMOTE POWER

FLASH FLASH OFF ON ON

platform config 626F

processor test 1142

processor test 1100

...

processor test 1142

memory config 7280

...

memory config 7280