System Startup, Configuration, and Shutdown Reference Manual (32650-90907)

Index
257
IO configurator command
, 212
LOG configurator command, 127
MISC configurator command, 143
SYSGEN command, 99, 102
ODE
exiting
, 208
ISL command, 204
ODE utility
activating
, 203
Online device configuration, 119
P
path information
stable storage
, 50
PDC, 203
PDC See processor dependent code, 19
peripheral devices
defined
, 17
permanent configuration files, 89
PERMYES
SYSGEN command
, 96
PERMYES in batch mode, 106
PERMYES in command files, 106
positional parameters
SYSGEN utility
, 95
primary boot paths, 110
processor dependent code (PDC), 19, 29, 45, 46
R
RAUTO
SYSFILE configurator command
, 162
RBOOT
SYSFILE configurator command
, 162
RCAT
SYSFILE configurator command
, 162, 163
RCMSL
SYSFILE configurator command
, 162, 163
RDCC
SYSFILE configurator command
, 162, 164
recovery, system failure, 70, 73, 74
redirecting SYSGEN input and output, 105
re-installation, 74
reload (INSTALL), 74
remote console
disabling access, 179
enabling access, 178
remote line
disconnecting
, 179
remote support modem
connecting to a session port
, 179
removing configuration changes, 101
removing system programs from a SYSGEN tape,
161
repeated parameters
SYSGEN utility
, 95
replacing a CMSL segment, 163
replacing a network configuration file, 164
replacing autoboot images, 162
replacing boot images, 162
replacing objects on the SYSGEN tape, 162
replacing operating system, 70
REPLY
MPE XL command, 213
reset, 20
resetting the system, 20
hard reset, 20
soft reset, 20
RESOURCE
MISC configurator command
, 144
resource allocations
setting
, 144
resource identification numbers
deleting
, 141
see RIN, 141
resources
allocating
, 144
retaining current configuration, 73, 77
RIN, 141
listing, 143
see resource identification numbers, 141
RIPL
SYSFILE configurator command, 162
RNMLIB
SYSFILE configurator command, 162
RS, 20
access port command, 20
hard reset, 20
RSPROG
SYSFILE configurator command
, 162
S
saving configuration changes, 101, 129, 150
scheduling an INSTALL, 75
scheduling an UPDATE, 70
scripting PERMYES, 106
scrolling
allowing
, 182
halting, 182
self-test, 20, 203
Series 920
default configuration
, 197
Series 922
default configuration
, 197
Series 922LX
default configuration
, 197
Series 922RX
default configuration
, 197
Series 925
default configuration
, 197
Series 925LX
default configuration
, 197
Series 932
default configuration
, 197
Series 935
default configuration
, 197
Series 948
default configuration
, 197
Series 949
default configuration
, 197
Series 950
default configuration
, 197
Series 958