System Startup, Configuration, and Shutdown Reference Manual (32650-90892)

Chapter 3 93
System Startup Functions
Dumping System Memory and Secondary Storage
[{ ;SINGLE-DISC [{ ;SINGLE-USER
;MULTI-DISC }] ;MULTI-USER }]
[{ ;SYSSTART
;NOSYSSTART }]
When the START option of the INSTALL utility is selected, the remaining options are
available.
INSTALL [{ ;START
;NOSTART } [options] ]
where options are: [;GROUP=
cgn ][LOGON= acct ]
[{ ;SINGLE-DISC [{ ;SINGLE-USER
;MULTI-DISC }] ;MULTI-USER }]
[{ ;SYSSTART
;NOSYSSTART }]
When the START option of the DUMP utility is selected, the remaining options are available.
DUMP [ SUBSET= { ALL [{ ;START
MEMORY }] ;NOSTART }[options] ]
Where options are:
[{ ;RECOVERY [{ ;SINGLE-DISC
;NORECOVERY }] ;MULTI-DISC }]
[{ ;SINGLE-USER [{ ;SYSSTART
;MULTI-USER }] ;NOSYSSTART }]
All available options are defined in Table 3-3..
Table 3-3. Utility Options
Options Functions
CONFIG or NOCONFIG
Default: NOCONFIG
During an UPDATE, this option specifies whether or not the configuration
data files on disk (CONFIG group), are replaced by those on tape
(CONFIG). If this option is not specified, the default is NOCONFIG
GROUP= configname
Default: GROUP =
CONFIG
When the system is booted with NORECOVERY, the group specified after
GROUP= is the source of configuration information. When performing an
UPDATE, INSTALL, or DUMP, this group is only in effect if START is
specified or defaulted. When a START command is entered, the group
specified (or defaulted) for it overrides any previous specification. Since
configuration groups reside in the SYS account, you do not specify the
account name.