System Startup, Configuration, and Shutdown Reference Manual (32650-90892)

56 Chapter3

System Startup Functions

Activating and Deactivating Autoboot and Autosearch Functions

Example 3-3. Displaying an Example of ISL Settings

ISL> display

Fastsize value is 0000000F

Autoboot is OFF (disabled)

Autosearch is OFF (disabled)

Primary boot path is 0/0/2/0.6.0.0.0.0.0

Primary boot path is (hex) 0/0/2/0.6.0.0.0.0.0

Alternate boot path is 0/0/1/0.6.0.0.0.0.0

Alternate boot path is (hex) 0/0/1/0.6.0.0.0.0.0

System console path is 0/0/4/0.0.0.0.0.0.0

System console path is (hex) 0/0/4/0.0.0.0.0.0.0

ISL>

Setting Fastsize

If fastsize is set to the wrong value, you cannot do installs or updates. The only value that

is acceptable is “F.” If you try to do an update or install with fastsize set to the wrong value,

you will receive an error message that reads UTILITY REQUIRES MORE MEMORY THAN IS

CONFIGURED.

Consider the following example.

ISL> DISPLAY

Fastsize value is 00000003

This fastsize value is invalid. You must reset it to “F”; therefore, at the ISL prompt, enter

Fastsize F, as in the following example.

ISL> FASTSIZE F

If you changed the value of fastsize, you must reset the system for the new value to take

effect. For more information on resetting the system, refer to Chapter 2 , “Initiating

System Activity.”

Listing Autoboot File Contents

To list the contents of the current autoboot ﬁle, enter either LISTAUTOFL or LSAUTOFL at

the ISL prompt:

ISL> LISTAUTOFL