System Startup, Configuration, and Shutdown Reference Manual (32650-90892)

184 AppendixA
Using the Access Port (AP)
Configuring the Console
Configuring the Console
Some of the terminal configuration parameters are important for proper AP operation.
Both terminals connected to ports T0 (system console) and T1 (remote support modem
port) should be configured with the following parameter settings:
From the DATACOMM CONFIGURATION menu:
Parity/DataBits None/8
Chk Parity NO
EnqAck YES
CS(CB)Xmit NO
RecvPace Xon/Xoff
XmitPace NONE
From the TERMINAL CONFIGURATION menu:
LocalEcho OFF
SPOW(B) NO
Line/Page(D) LINE (**necessary during control mode**)
ReturnDef Return
Parameters not mentioned can be set to any value and do not affect AP operation.
NOTE The AP is designed to operate with the HP 700/92 terminal. There have been
no deliberate steps taken to preclude operation with other terminals (for
example, the AP does not check the terminal identification and refuse to
operate with anything else), but no other terminals have been tested for
proper operation. Use other terminals at your own risk.
Entering Control Mode and Using the Command Interpreter
Control mode is the mode of operation needed to use the access port commands. Activate
the AP control mode interface by entering
CTRL B at the system console:
:CTRL B
CM>
To use the access port command interpreter, enter a two-character AP command at the
control mode prompt (CM>), followed by a carriage return:
CM>RS
Execution of this command irrecoverably halts
all system processing and I/O activity and
restarts the computer system.
.
.
.
If the AP command parser does not recognize the two characters entered as a command,