System Startup, Configuration, and Shutdown Reference Manual (32650-90892)

Chapter 4 113
Using the System Generator (SYSGEN)
Generating a System Load Tape
• To create a system load tape with user files stored after it, enter the following
command:
sysgen>TAPE STORE="
filesetlist "
You can list the user files that you wish to store as input to the
STORE= parameter.
Note that the string of file names to be stored after the SLT must be enclosed in
quotes. You can also use the wildcard @ to include all users files on the system
(@.@.@), in specific accounts (@.@.SYS, @.@.AR), and in specific groups of accounts
(@.PUB.SYS, @.CURRENT.AR).
The system responds by issuing a message similar to the following:
?10:15/#92/46/LDEV# FOR "SYSGTAPE" ON TAPE (NUM)
Respond to the tape request to start the STORE when the system issues the above
message. When the store is complete, the system issues a message indicating that it has
completed the tape:
**Boot tape is successfully built**
11.After all the files are stored, unload the tape and write- protect it. Label the tape and
store it in a secure location with other backup materials.