System Debug Reference Manual (32650-90888)

528 Chapter13
Standalone Analysis Tool (SAT)
Operating Restrictions
— The FPMAP command is automatic and is executed at boot time. When the most
recent process is executing in REAL mode, it may be necessary to switch to another
PIN and issue the FPMAP command explicitly. Since only SL.PUB.SYS CM symbols
are accessible, no parameters are need with FPMAP.
— For standard functions nmaddr and nmfile, only addresses contained in the system
library will succeed.
— For standard function strmax, SAT strings are limited to 1024 characters.
• The following System Debug commands cannot be used in SAT:
: Call the MPE XL command interpreter.
ABORT Abort the process.
B All forms of the Break command.
BD Breakpoint Delete.
BL Breakpoint List.
CLOSEDUMP Close a dump file.
C[ONTINUE] Continue.
DATAB Data Breakpoint.
DATABD Data Breakpoint Delete.
DATABL Data Breakpoint List.
DEBUG Enter the debugger.
DUMPINFO Display dump file information.
F All forms of the Freeze command.
FINDPROC Dynamically load NL library procedure.
FT Format type.
FV Format virtual.
GETDUMP Read in a dump tape to create a dump file.
KILL Kill a process.
LIST Create list files.
LOADINFO Display currently loaded program/libraries.
LOADPROC Dynamically load CM library procedure.
LOG Create log files.
M Most forms of the Modify command.
(MSEC, MV, MZ, are supported).
MAP Map a file into virtual memory.