System Debug Reference Manual (32650-90888)

Chapter 13 527
Standalone Analysis Tool (SAT)
Operating Restrictions
00000007
R16/00000000 0000000e 00000003 00678000 8118a000 00000014 c6809880
00000000
R24/00000000 00000000 0004007b c0200008 fba8b500 0000000e 8118a6e0
00d84200
Space Registers
---------------
S 0/0000000a 0000010d 00000000 00000000 0000000a 0000000a 0000000b
0000000a
Control Registers
-----------------
C 0/00000000 00000000 00000000 00000000 00000000 00000000 00000000
00000000
C 8/00000102 00000000 00000080 00000002 00000000 00000000 0008d000
ffffffff
C16/fd3c3e64 0000000a 000ad8a8 b7e07000 0000000a 00000000 0004ff0a
00000000
C24/005e4200 00634200 c0000000 001efb98 ffffffff 000888d0 fc8a711d
00007ffd
Current CPU: 0 Original CUP: 0 Monarch CPU: 0 MP array at:
720000
Main memory: 27fffff
Hash table: 634200.40000 Pdir table: 5e4200.50000
RGLOB: 678000 ICS: 8a9000 TCB_BASE: 8d1000 TCB: 8d6900
Last Pin: 25 DISP running
$1 ($0) nmsat >
4. Analyze the failure. Most of the System Debug commands are available to you;
restrictions are listed below. If you want to make a dump tape, return control to ISL
with the EXIT command, then invoke the DUMP utility.
Operating Restrictions
The following limitations exist in SAT:
• The symbolic access functions are not available.
• The only symbols that are accessible in CM are the SL.PUB.SYS symbols.
• No operation that involves the file system, such as use files, list, or log files is allowed,
since the file system is not available in a standalone environment.
• Some commands and functions are different in SAT:
— The EXIT and C[ONTINUE] commands return control to ISL. The EXIT command
has two additional parameters,
ISL_Command and ABORT . An example follows in
"SAT Commands" in this chapter.