System Debug Reference Manual (32650-90888)

254 Chapter6
System Debug Command Specifications M-X
SET
When the RETURN command is encountered, a value is returned, and the macro execution
is immediately terminated. Additional commands within the macro that follows an
executed RETURN command are never executed.
Parameters
value The value to be returned by the macro. If value is not specified, the
default macro return value is returned.
Examples
$nmdebug > macro test=$123 (p1) {if p1 < 10 then return p1 else ret}
$nmdebug > wl test(3)
$3
$nmdebug > wl test(45)
$123
A macro named test is defined with a default return value of $123.
When the macro is called with the parameter of 3, the parameter is less than $10, so the
parameter value is returned.
In the second call, because $45 is larger than 10, the default macro return value $123 is
returned.
$nmdebug > return 33
The RETURN command must be used within a macro body. (error #1449)
The RETURN command can be used only within a macro.
Limitations, Restrictions
none
SET
Sets new values for a select subset of all user configurable options.
Syntax
SET
SET [ O[CT] | %
D[EC] | #
H[EX] | $ ] [ IN
OUT ]
SET [ CRON
CROFF ]