System Debug Reference Manual (32650-90888)

Chapter 4 123
System Debug Command Specifications :-Exit
DR
Examples
$nmdat > dptree
1 ( PROGEN.PUB.SYS )
2 ( LOAD.PUB.SYS )
3 ( .. )
4 ( .. )
5 ( .. )
6 ( LOG.PUB.SYS )
7 ( SYSMAIN.PUB.SYS )
9 ( SESSION.PUB.SYS )
a ( JSMAIN.PUB.SYS )
15 ( CI.PUB.SYS )
16 ( JSMAIN.PUB.SYS )
17 ( CI.PUB.SYS )
12 ( FCOPY.PUB.SYS )
8 ( JOB.PUB.SYS )
b ( JSMAIN.PUB.SYS )
c ( DIAGMON.DIAG.SYS )
d ( RUNPROG.DIAG.SYS )
e ( MEMLOGP.DIAG.SYS )
f ( RUNPROG.DIAG.SYS )
10 ( LOGGER.DIAG.SYS )
$nmdat >
Prints out the entire process tree.
Limitations, Restrictions
none
DR
Displays contents of the CM or NM registers.
Syntax
DR [ cm_register ] [ base ]
DR [
nm_register ] [ base ]
Parameters
cm_register The CM register to be displayed. This can be the:
DB The stack base relative word offset of DB.
DBDST The DB data segment number.
DL The DL register word offset, DB relative.