SNA NRJE User/Programmer Reference Manual (30292-90006)

92 Chapter3
User Commands
SUBMIT
PunchFile
Used to specify routing for output data sets that are
sent to an NRJE logical punch on the standard form.
FormFile
Refers to print or punch output routed to any form
other than the standard form.
PR=, PU=, and FO= specifications require the use of the
Job Log. Use of these parameters is not supported for
workstations connected to a VSE/POWER host.
One of each type of file (PRINT, PUNCH, and FORMS) can
be specified by any of the following:
• A formal file designator (*
fileid ) which
backreferences an actual file designator.
• The logical device number ( ldev ) of an MPE output
device (numeric entry).
• An MPE device class name, enclosed in double
quotation marks (
“DevClass” ).
• An actual file designator (alphanumeric). The file
must be built before the job is submitted. Both the
user and MANAGER.SYS must have READ/WRITE
access to the destination file.
• An alternate form name (formid) used as a key into
the Lookup Table. This designation is made with
single quotation marks (
‘formid’ ). This
designation references a predefined file equation in
the NRJE output management Lookup Table. See
below under “Default FOPEN Parameters Used,”
and under “Job and Output Management” in
Chapter 4 , “Job Output,” for additional information.
Limitations:
• The total length of
PrintFile , PunchFile , and
FormFile entries cannot exceed 197 bytes. Each
item cannot exceed 86 bytes in length.
• SNA NRJE does not support NOWAIT I/O,
MULTIRECORD ACCESS, or any combination of
file equation attributes which require Privileged
Mode to open the file.
• The maximum record width for output files is
255 bytes and the minimum is 40 bytes. Output
directed to files which are not wide enough to
accommodate the received data records may be