SNA NRJE User/Programmer Reference Manual (30292-90006)

68 Chapter3
User Commands
DISPLAY
• The value of the reader outfence. You might need to
know this when you use the
PRIORITY parameter of
the SUBMIT command.
• The system OutFence value.
WRITER Displays information about each logical writer
configured for this workstation:
• Name of the writer.
• Logical device number (
ldev ), logical device class
names, or “formid” entry in the Lookup Table.
• The FORCED flag value: forces the formid to use the
default output destination when output is routed to
the writer and alternative routing is not specified in
SUBMIT command. Will be Y or N.
• Output priority.
• Translation code.
ACTIVEWS Provides a list of all active NRJE workstations on your
HP 3000.
LUTABLE Displays information about each logical unit:
• Logical unit name. An asterisk (*) beside a logical
unit name indicates that it is active.
• Chain size: the number of RUs sent to the host
before requesting a positive response.
• Logical unit address.
• Auto-start flag.
Wsid Overrides the default workstation named in your NRJE
command. All information received is for workstation
Wsid . Subsequent commands are not affected.
Description
The DISPLAY command enables you to obtain a broad range of
information about NRJE workstations. You can obtain information
about transmission queues, logical writers, and active workstations.
If you enter this command without any parameters, NRJE displays all
the information possible about the default workstation. If you enter a
DISPLAY command with only a
Wsid parameter, NRJE displays all the
information possible about the workstation specified in that parameter.
The
Wsid parameter overrides a default workstation established earlier
in an NRJE command. As the following examples show, you can vary
the output from the DISPLAY command, depending on the parameters
that you enter.