SNA NRJE User/Programmer Reference Manual (30292-90006)

Chapter 5 175
User Intrinsics
NRJEWSInfo
NRJEWSInfo
Obtains general information about a workstation.
Syntax
BA I BA BA BA IA
NRJEWSInfo ( Wsid , ActiveFlag , JES , Remote , Reserved , Result )
Parameters
Wsid An eight-character input byte array. The Wsid
parameter identifies your workstation. It must contain
a left-justified alphanumeric name beginning with a
letter. If the workstation identifier is less than eight
characters long, it must be followed by blanks.
ActiveFlag An output integer variable. The ActiveFlag
parameter is used to learn whether your workstation is
communicating with a host. Possible values for this
parameter are as follows:
• 1 = Your workstation is active.
• 2 = A stop is pending.
• 4 = A protocol shutdown is pending.
• %10 = A monitor request is pending.
• %20 = LU activation is pending.
• %40 = Your workstation is inactive.
JES An eight-character output byte array. The JES
parameter is used to identify the job entry system
configured at your host. Information is returned
left-justified, with trailing blanks if needed.
Remote An eight-character output byte array. Use the
Remote parameter to learn how the host system
identifies your workstation.
For example, RMT11 is returned as
RMT11
Reserved This field is not in use at this time.
Result An eight-element integer output array (required).
The Result array contains error codes that occurred
during execution of this intrinsic.
The first element of the Result array is set to zero if no