SNA NRJE Node Managers Guide (30292-90007)

Chapter 6 93
Commands
NRJECONTROL STOP
NRJECONTROL STOP
Stops active LU-LU sessions in an orderly manner.
Syntax
NRJECONTROL STO[P];W[SID]= Wsid [;LU= LUName [, LUName ]...]
Parameters
Wsid Required. The workstation name. This can be up to
eight alphanumeric characters long; the first character
must be alphabetic.
The workstation must have been configured.
LUName For NRJE/V, this is the name of the SNA node LU class
whose LU-LU sessions you want to stop. (Node classes
are configured on the MPE V SNA Configuration:
Classes screen.) For NRJE/XL, this is the configured LU
Name (not the NAU number) of the LU whose LU-LU
sessions you want to stop. (LUs are configured on the
MPE XL SNANode Configuration: PU and LU Data
screen.)
The name can be up to eight alphanumeric characters
long; the first character must be alphabetic. You can
specify a maximum of five
LUNames . If you do not
specify any
LUNames , all active LUs for that
workstation are stopped.
Description
When the NRJECONTROL STOP command is issued, active LU-LU
sessions are stopped in an orderly manner. This differs from the
NRJECONTROL HALT command, which causes an immediate termination
of the LU-LU sessions. You can halt all LU-LU sessions by not
specifying any
LUNames , or you can select sessions to halt by specifying
LUNames . Activities at the workstation can consist of several LU-LU
sessions. All current activities of LU-LU sessions will continue to
completion before stopping. This is called quiescing. Note that intrinsic
tracing for the workstation is not stopped.
NOTE Control is returned to NRJE before completing execution of this
command.