SNA NRJE Node Managers Guide (30292-90007)

Chapter 3 49
SNA NRJE Configuration
Configuring SNA NRJE
Writer Name
The name of the new writer you are configuring, or the
existing writer whose configuration you are modifying.
The name must be in one of these formats:
•PR
x = a logical printer, where x is an integer from 1
through 7.
•PU
x = a logical punch, where x is an integer from 1
through 7.
Host Configuration:
• JES2: This must match the PR
m or PU m portion,
respectively, of the R
nnnn .PR m or R nnnn .PU m macro;
see Table 3-4.
• JES3: This must match the number of the device
(PR
m or PU m ) in the JNAME parameter of the DEVICE
macro; see Table 3-6.
• VSE/POWER: Specify PR1 and PU1.
New Name
The new name of an existing writer. The name must be
in one of these formats:
•PR
x = a logical printer, where x is an integer from 1
through 7.
•PU x = a logical punch, where x is an integer from 1
through 7.
Host Configuration:
• JES2: This must match the PR
m or PU m portion,
respectively, of the R
nnnn .PR m or R nnnn .PU m macro;
see Table 3-4.
• JES3: This must match the number of the device
(PR
m or PU m ) in the JNAME parameter of the DEVICE
macro; see Table 3-6.
• VSE/POWER: Specify PR1 and PU1.
Once you have entered the new name, press
[f4]
[Rename]; the writer is then renamed.
Configured NRJE Writers (Under Workstation)
For display only. The names of the logical writers
that have been configured for the workstation. You can
configure a maximum of 14 writers for a workstation
(seven readers and seven writers). Note that the total
number of configured writers must match the number
of writers configured in the host job entry subsystem.