SNA NRJE Node Managers Guide (30292-90007)

42 Chapter3
SNA NRJE Configuration
Configuring SNA NRJE
• JES3: This must match the FORMS subparameter of
the
OUTSERV global parameter; see Table 3-5. If
FORMS is not specified, enter 1PRT here.
• VSE/POWER: Enter all blanks.
Host Standard Punch Form Name
The default punch form name for the workstation. This
must match the name of the form in the Peripheral
Data Information Record (PDIR) for output routed to
the standard form on a punch device.To determine this,
see the SNA NRJE User/Programmer Reference
Manual.
Default: STD
Host Configuration:
• JES2: This must match the
&STDFORM global
parameter; see Table 3-3. Note that if you are using
JES2 version 1.3.6 (or later) or 2.1.5 (or later), the
&STDFORM parameter is different; use the migration
tables to determine the correct
&STDFORM . If
&STDFORM is not specified, enter STD here.
• JES3: This must match the
CDSTOCK subparameter
of the
OUTSERV global parameter; see Table 3-5. If
CDSTOCK is not specified, enter 5081 here.
• VSE/POWER: Enter all blanks.
File
For display only. The name of the configuration file.
Once you have entered all of the necessary information
on this screen, press [f6] [Save Data].
After the information is processed, press
[f8]
[Prior Screen] to redisplay the NRJE Configuration:
Workstation Data screen. Then, if you need to configure
LUs for the workstation, press
[f1] (Go To LU).
Otherwise, press
[f8] [Prior Screen] until you get to the
NMMGR menu screen or select screen you need next.
LU Data Screen
Once you have specified all of the workstation data, you are ready to
configure the LUs for the workstation. You do this on the NRJE
Configuration: LU Data Screen, as shown in Figure 3-6. Select this
screen by pressing
[f1] (Go To LU) on the NRJE Configuration:
Workstation Data Screen. (You can go directly to this screen from any
screen by typing @NRJE.
wsid .LU in the command window and pressing