SNA NRJE Node Managers Guide (30292-90007)

Chapter 3 39
SNA NRJE Configuration
Configuring SNA NRJE
Job Management
Required. Enter Y to cause the output routing options
(PRINT, PUNCH, and FORMS)oftheSUBMIT command to
be supported; N, otherwise.
Default: Y
Logical Unit RU Size
Required. The maximum size of the RUs, in bytes,
that NRJE can send to the host.
Values: 256, 512, and 768 (integer)
Default: 256
Host Configuration: This must match the
RUSIZES
parameter of the MODEENT macro in the Logmode Table
entry used by the workstation; see Table 3-2. Note that
in the MODEENT definition the RU sizes are specified in
hexadecimal (for example, X'85' for 256).
• JES2: This must match the
BUFSIZE parameter in
the RMT
nnnn macro; see Table 3-4. Note that the
BUFSIZE parameter overrides the RUSIZES
parameter mentioned above.
• JES3: This must match the
BUFSIZE subparameter
of the
BUFFER global parameter; see Table 3-5. Note
that the
BUFSIZE subparameter overrides the
RUSIZES parameter mentioned above.
• VSE/POWER: 256 is the only valid value.
File
For display only. The name of the configuration file.
Once you have entered all of the necessary information
on this screen, press [f6] [Save Data]. After the
information has been processed, press
[f4]
(Go To PAGE2) to specify more information.
Workstation Data Page 2 Screen
This screen is a continuation of the NRJE Configuration: Workstation
Data Screen, as shown in Figure 3-5. Select this screen by pressing
[f4]
(Go To PAGE2) on the Workstation Data screen. (You can go directly to
this screen from any screen by typing @NRJE.
wsid .PAGE2 in the
command window and pressing
[ENTER].) Here you specify more
information about the workstation.