SNA NRJE Node Managers Guide (30292-90007)

194 AppendixA
Result Codes and Messages
SNA NRJE Error Messages
job, consolidate the files as follows: (1) append several files together and
SUBMIT again, and (2) write a routine using the NRJESubmit intrinsic.
746 MESSAGE: SEMICOLON OR CARRIAGE RETURN IS EXPECTED.
(CI=746)
CAUSE: A semicolon or carriage return was omitted.
ACTION: Correct the information and re-enter the data.
747 MESSAGE: INFILE OPTION IS INVALID. (CI=747)
CAUSE: An invalid infile option was specified.
ACTION: Correct the information and re-enter the data.
748 MESSAGE: NO WORKSTATION IS SELECTED. (CI=748)
CAUSE: No workstation identification has been specified.
ACTION: Enter an NRJE command with a workstation identification to
specify a default workstation, or use a workstation identification with
the commands that require it.
751 MESSAGE: UNABLE TO EXECUTE RUN COMMAND.
CREATEPROCESS ERROR # !. (CI=751)
CAUSE: A RUN command has been issued within the CI but failed.
ACTION: Check and make sure the program does exist.
752 MESSAGE: KEYWORD VALID ONLY IN THE SUBMIT OR DISPLAY
COMMAND. (CI=752)
CAUSE: A keyword has been entered out of context.
ACTION: Correct and re-enter the command.
753 MESSAGE: REDO INPUT EXCEEDS THE MAXIMUM COMMAND
LENGTH. (CI=753)
CAUSE: The input to correct a command is too long.
ACTION: Correct the command in stages.
754 MESSAGE: REDO INPUT CONTAINS GARBAGE DELETION. (CI=754)
CAUSE: Garbage characters detected after delete characters (D).
ACTION: Re-enter.
755 MESSAGE: UNABLE TO OPEN THE HOST CONSOLE. (CI=755)
CAUSE: The workstation is not active, or the host console is already in
use.
ACTION: Use the DISPLAY command, or its intrinsic equivalent, to
determine whether the workstation is active, or the host console is
already in use. Wait until the workstation is active, or the host console
is available, and re-enter the command.