SNA NRJE Node Managers Guide (30292-90007)

Appendix A 193
Result Codes and Messages
SNA NRJE Error Messages
ACTION: Correct the MPE command and re-enter the data.
739 MESSAGE: UNABLE TO EXECUTE MPE COMMAND. MPE ERROR # !.
(CI=739)
CAUSE: An MPE command that was entered from the NRJE subsystem
could not be executed. The meaning of MPE error number ! can be
found in System Operation and Resource Management Reference
Manual. The command to be executed may be limited to non-break
mode.
ACTION: In order to execute the MPE command, EXIT from NRJE,
execute the MPE command, and then re-enter NRJE.
740 MESSAGE: MAXIMUM OF 5 LU NAMES CAN BE ENTERED. (CI=740)
CAUSE: There are more than five LU name parameters in the
command.
ACTION: Reduce the number of LU names to five, or less, and re-enter
the command.
741 MESSAGE: LENGTH OF THE INFILE NAME IS OUT OF RANGE.
(CI=741)
CAUSE: An
InFile reference is too long.
ACTION: An
InFile reference can be a fully qualified file name, or *
followed by a formal designator reference to a FILE command. All parts
of a fully qualified file name, and a formal designator, must begin with a
letter and are eight or fewer alphanumeric characters long.
742 MESSAGE: DUPLICATE INFILE OPTION IS DETECTED. (CI=742)
CAUSE: An
InFile reference was followed by a (C,C) or (T,T).
ACTION: Correct the command and re-enter it.
743 MESSAGE: EXPECTED A RIGHT PARENTHESIS AFTER THE INFILE
OPTIONS. (CI=743)
CAUSE: A right parenthesis was omitted.
ACTION: Correct the command and re-enter it.
744 MESSAGE: EXTRANEOUS TOKEN AFTER THE INFILE OPTION IS
DETECTED. (CI=744)
CAUSE: A token that is not a comma, semicolon, or carriage return is
detected after an infile option.
ACTION: Refer to NRJE manual and re-enter.
745 MESSAGE: MAXIMUM OF 5 INFILES CAN BE ENTERED. (CI=745)
CAUSE: Too many infiles have been specified.
ACTION: If the SUBMIT command is for more than one job, divide the
task into several SUBMIT commands. If the SUBMIT command is for one