SNA NRJE Node Managers Guide (30292-90007)

124 Chapter6
Commands
VERIFY
VERIFY
Verifies the entries in the Formid Lookup Table.
Syntax
VERI[FY][;W[SID]= Wsid ]
Parameter
Wsid The workstation name. This can be up to eight
alphanumeric characters long; the first character must
be alphabetic.
If you omit this parameter, the default workstation
identifier is used. You can specify a default workstation
identifier in the NRJE command.
Description
After building the Formid Lookup Table and then configuring it in the
NRJE Configuration: Workstation Data Page 2 screen, you should use
the VERIFY command to verify all of the records. Note that all of the
devices in the Formid Lookup Table must be available. Also, if your
workstation is established over a data communications line (DS line),
the line must be open. For additional information about the Formid
Lookup Table, see the SNA NRJE User/Programmer Reference
Manual.
You should be logged on as MANAGER.SYS,NRJE when you issue this
command. If any Formid Lookup Table records reference a tape device,
then a tape mount request will be sent to the operator’s console. This
command can be terminated by a
[CTRL]-Y.
Text Reference
See RELOAD earlier in this chapter for information about reloading the
Formid Lookup Table.