SNA NRJE Node Managers Guide (30292-90007)

110 Chapter6
Commands
RDRFENCE
RDRFENCE
Updates the outfence value of the NRJE workstation reader.
Syntax
RDRF[ENCE] ReaderOutFence [;W[SID]= Wsid ]
Parameters
ReaderOutFence
Required. The output fence for the workstation reader.
This is an integer from 1 through 14; however, note that
you can specify 0 to use the system output fence,
instead. If you do this, the
ReaderOutFence value is
changed to the value of the system output fence.
When an LU is configured to transmit the spooled file,
any spooled file whose priority exceeds the value of
ReaderOutFence is transmitted once the workstation is
in communication with the host.
Wsid
The workstation name. This can be up to eight
alphanumeric characters long; the first character must
be alphabetic.
If you omit this parameter, the default workstation
identifier is used. You can specify a default workstation
identifier in the NRJE command.
Description
This command updates the outfence value of the NRJE workstation
reader. You can specify a particular workstation by specifying a
Wsid .
This command is equivalent to the following MPE command for NRJE
spool files:
:OUTFENCE ReaderOutFence ;LDEV= ldev
You can influence the transmission of spooled files from the reader
transmission queue to the host by varying
ReaderOutFence . Any
spooled file in the workstation’s reader transmission queue with an
output priority less than or equal to the value of
ReaderOutFence is
deferred until one of these events takes place:
• The value of
ReaderOutFence is lowered with a RDRFENCE
command.