SNA NRJE Node Managers Guide (30292-90007)

Chapter 6 105
Commands
HALT
HALT
Stops active LU-LU sessions immediately.
Syntax
H[ALT][;W[SID]= Wsid ][;LU= LUName [, LUName ]...]
Parameters
Wsid The workstation name. This can be up to eight
alphanumeric characters long; the first character must
be alphabetic.
If you omit this parameter, the default workstation
identifier is used. You can specify a default workstation
identifier in the NRJE command.
LUName For NRJE/V, this is the name of the SNA node LU class
whose LU-LU sessions you want to halt. (Node classes
are configured on the MPE V SNA Configuration:
Classes screen.) For NRJE/XL, this is the configured LU
Name (not the NAU number) of the LU whose LU-LU
sessions you want to halt. (LUs are configured on the
MPE XL SNANode Configuration: PU and LU Data
screen.)
The name can be up to eight alphanumeric characters
long; the first character must be alphabetic. You can
specify a maximum of five
LUNames . If you do not
specify any
LUNames , all active LUs for the workstation
are halted.
Description
This command enables you to stop active LU-LU sessions immediately.
This differs from the STOPWS command, which causes an orderly
termination of the LU-LU sessions. You can specify a particular
workstation by specifying a
Wsid . You can halt all active LU-LU
sessions by not specifying any
LUNames , or you can select sessions to
halt by specifying
LUNames .
NOTE Control is returned to NRJE before completing execution of this
command.