SNA Link/iX Node Managers Guide (30291-90507)

98 Chapter3
Logging Configuration
Configuring Logging
CLAS0011: warnings
Conditions that should be noticed, but which do
not prevent normal operation of HP SNADS/XL.
CLAS0012: subsystem information
HP SNADS/XL subsystem information
Success or failure of the VERIFY Manager
command
Token Ring Link (SUB0061):
CLAS0001: Errors
CLAS0002: warnings
CLAS0003: informational messages
NOTE
If you want the logging events for only a specific logging subsystem and
class to be displayed at the list devices of users, see “Enabling Users for
a Specific Subsystem and Class” later in this chapter.
File
For display only. The name of the configuration file.
Once you have entered all of the logging information,
press
[f6] (Save Data).
Then, if you do not want to configure logging
information for other SNA subsystems, press [f5]
(Validate HP-IBM) to validate the logging
configuration you just did. Once the logging
configuration is validated, press
[f4] (Exit Logging) to
return to the screen shown in Figure 3-2, “HP-IBM
Configuration Screen.
If you want to configure logging information for other
SNA subsystems, (1) press
[f8] (Prior Screen) once,
which places you at the screen shown in Figure 3-4,
“IBM Logging Configuration (2) Screen, or (2) press
[f8]
(Prior Screen) twice, which places you at the screen
shown in Figure 3-3, “IBM Logging Configuration (1)
Screen.