SNA Link/iX Node Managers Guide (30291-90507)

Chapter 2 57
SNA Node and Link Configuration
Configuring the SNA Node and Link
with ID BLK); refer to Table 2-8 and
Table 2-10.
Local Control Point Name
(Token Ring only) Required for APPC over Token Ring
Link. The name by which the HP e3000 node is known
to the remote system.
Host Configuration: HP recommends that you use the
PU name (the SNA Node Name field in the SNA Node
Configuration screen) in this field.
AS/400 Configuration: For APPN, the RMTCPNAME in the
APPC display controller description must match this
field, refer to Table 2-10. Otherwise, HP recommends
that you use the PU name (the SNA Node Name field in
the SNA Node Configuration screen) in this field.
File
For display only. The name of the configuration file.
Once you have entered all of the PU information, press
[f6] (Save Data).
After the information is saved, if you need to configure
LU information, press [f2] (Go To LUDATA); this places
you at Figure 2-5, “LU Data Screen.”
If you need to configure link information, press [f1]
(Go To LINKDATA). If you specified SDLC for the Link
Type field on Figure 2-4, “PU Data Screen,” you are
placed at Figure 2-7, “SDLC Link Data Screen.” If you
specified X.25 for the Link Type field, you are placed at
Figure 2-8, “X.25 Link Data Screen.” If you specified
TOKEN for the Link Type field, you are placed at Figure
2-11, “Token Ring Link Data Screen.” Each of the
screens are described later in this chapter.
If you do not need to configure LU information or link
information, press
[f8] (Prior Screen) until you get to
the screen you need next.