SNA Link/iX Node Managers Guide (30291-90507)

Appendix A 273
Messages
LAN Error Messages
184 MESSAGE: Type 2 connection already exists.
CAUSE: Two transports are configured to use the same MAC addresses
and SAPs.
ACTION: Correct the NMMGR configurations and restart the driver.
185 MESSAGE: Type 2 connection not available.
CAUSE: The driver has reached the maximum number of supported
connections.
ACTION: Shut down some connections to free up resources.
186 MESSAGE: Type 2 Connection ID invalid.
CAUSE: A transport tried to send a message to the driver with an
invalid connection identifier.
ACTION: Write down the error information and contact your
Hewlett-Packard support contact.
187 MESSAGE: Type 2 non-fatal protocol error.
CAUSE: An unexpected packet format was received.
ACTION: Disregard if the connection is working properly, and no other
errors occurred. If the connection will not function or other errors have
occurred, write down the error information and contact your
Hewlett-Packard support contact.
188 MESSAGE: Type 2 non-fatal protocol error.
CAUSE: An unexpected packet format was received.
ACTION: Disregard if the connection is working properly, and no other
errors occurred. If the connection will not function or other errors have
occurred, write down the error information and contact your
Hewlett-Packard support contact.
189–197 MESSAGE: Type 2 non-fatal software error.
CAUSE: A non-fatal Type 2 driver software error occurred.
ACTION: Disregard if the connection is working properly, and no other
errors occurred. If the connection will not function or other errors have
occurred, write down the error information and contact your
Hewlett-Packard support contact.
198 MESSAGE: Type 2 non-fatal protocol error.
CAUSE: An unexpected packet format was received.
ACTION: Disregard if the connection is working properly, and no other
errors occurred. If the connection will not function or other errors have
occurred, write down the error information and contact your
Hewlett-Packard support contact.