SNA Link/iX Node Managers Guide (30291-90507)

Appendix A 265
Messages
LAN Error Messages
59 MESSAGE: The NIO LAN/console card detects a bad length of the
configuration data buffer.
CAUSE: The problem is caused by data corruption in the configuration
quad.
ACTION: Write down the error information displayed on the console,
submit an CR, take a dump and call your Hewlett-Packard support
contact.
CAUSE: The problem is caused by a bad NIO LAN/console backplane.
ACTION: Your Hewlett-Packard representative must run diagnostics on
the LAN/console card.
60 MESSAGE: The NIO LAN/console card detects bad multicast address
in the configuration data.
CAUSE: A bad multicast address was entered into the Multicast Address
Table.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard support contact.
CAUSE: The problem is caused by a bad NIO LAN/console backplane.
ACTION: Your Hewlett-Packard representative must run diagnostics on
the LAN/console card.
61 MESSAGE: The NIO LAN/console card detects a bind request to
illegal register.
CAUSE: The problem is caused by a link driver internal error.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard support contact.
CAUSE: The problem is caused by a bad NIO LAN/console backplane.
ACTION: Your Hewlett-Packard representative must run diagnostics on
the LAN/console card.
62 MESSAGE: The NIO LAN/console card detects a bad Station Address
in CONFIG_SA.
CAUSE: The problem is caused by configuring the wrong Station
Address in NMMGR.
ACTION: Use NMMGR to verify that the configured Station Address is
correct.
CAUSE: The problem is caused by a bad NIO LAN/console backplane.
ACTION: Your Hewlett-Packard representative must run diagnostics on
the LAN/console card.