SNA Link/iX Node Managers Guide (30291-90507)

240 AppendixA
Messages
SDLC Link Shutdown Error Messages
SDLC Link Shutdown Error Messages
Listed below are the messages that might occur when you are stopping
the SDLC link. These messages occur when the SNACONTROL STOP
command calls the WAN_Kill_Module procedure and encounters an
error. Depending on the logging configuration for the SDLC Link
subsystem, these messages are logged to the console, to disk, or both.
The messages are logged in this format:
Linkname = LinkName Event Type = EventType
Log Class = LogClass Path = Path
Error Num = ErrorNumber Status = Status
(Note that LinkName is the same as the name of the node.) The
messages are listed below in numerical order according to
ErrorNumber .
51 MESSAGE: Could not stop trace.
CAUSE: Tracing might have been turned off with the SNACONTROL
TRACEOFF command, but the link software status indicates that it is on.
ACTION: Ignore this problem unless you are experiencing other
problems. If you are, write down the error information displayed on the
console and call your Hewlett-Packard support contact.
52 MESSAGE: The link is not in the link table.
CAUSE: The node specified in the SNACONTROL STOP command is not
active.
ACTION: Unless the specified
NodeName parameter is not correct, no
action is required: The link has already been shut down.
53 MESSAGE: The link type is not SDLC, LAP-B or RJE.
CAUSE: The caller of this module did not set the link type to SDLC,
LAP-B, or RJE BSC. Since you are using an SDLC link, the link type
must be set to SDLC.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
54 MESSAGE: Could not delete the link from the link table.
CAUSE: The
NodeName specified in the SNACONTROL STOP command is
not in the link table.
ACTION: Ensure that the NodeName is correct and try again. The link
might have already been shut down.